CJT Concealed Joist Ties

The CJT is a concealed connector. It can be installed three ways: with no routing of header/post or beam; a routed header/post, or a routed beam.

Material: 12 gauge

Finish: Galvanized

Installation:

Use all specified fasteners. See General Notes.
The CJT Pack is supplied with all pins and screws required. Screws require a hex head driver.
Router end of beam for screw heads for flush installation.
The joist/beam may be sloped to 45° with full table loads.
To provide maximum beam width for use with short pins, center in beam.
To order: specify short (e.g. CJT3S) or long pins (e.g. CJT3L) (see footnote #1 below).

Options: See Technical Bulletin T-CJT.

Warning:
This connector requires special attention to ensure correct installation. The beam must be installed perpendicular to the support member. The connection's components may be damaged if the beam is rotated from its opposite end during or after installation. Damaged components may not be noticeable and may reduce the connector's load carrying capacity.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
CJT	See specific model numbers for code listings.
CJT3		ESR-2614 / ESR-2523 *		FL10865
CJT3L	No code listing. Please contact us for test data.
CJT3S	No code listing. Please contact us for test data.
CJT4		ESR-2614 / ESR-2523 *		FL10865
CJT4L	No code listing. Please contact us for test data.
CJT4S	No code listing. Please contact us for test data.
CJT5		ESR-2614 / ESR-2523 *		FL10865
CJT5L	No code listing. Please contact us for test data.
CJT5S	No code listing. Please contact us for test data.
CJT6		ESR-2614 / ESR-2523 *		FL10865
CJT6L	No code listing. Please contact us for test data.
CJT6S	No code listing. Please contact us for test data.

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson AutoCad Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
CJT	None for this model	None for this model
CJT3	CJT3: DWG \| DXF CJT3 front view: DWG \| DXF CJT3 left view: DWG \| DXF	None for this model
CJT3L	None for this model	None for this model
CJT3S	None for this model	None for this model
CJT4	None for this model	None for this model
CJT4L	None for this model	None for this model
CJT4S	None for this model	None for this model
CJT5	CJT5: DWG \| DXF CJT5 front view: DWG \| DXF CJT5 left view: DWG \| DXF	None for this model
CJT5L	None for this model	None for this model
CJT5S	None for this model	None for this model
CJT6	CJT6: DWG \| DXF CJT6 front view: DWG \| DXF CJT6 left view: DWG \| DXF	None for this model
CJT6L	None for this model	None for this model
CJT6S	None for this model	None for this model