CBSQ Column Base, Quick-Install
Product Details
The CBSQ is designed to be the interface between columns and their foundations. The main function of this column base is to link the column to the concrete footing surface and thereby transmit the structure’s stresses to the foundation. The CBSQ uses Strong-Drive® SDS Heavy-Duty Connector screws (included), which allow for fast installation and reduced reveal, and provide a greater net section area of the column than bolts.
Key Features
- 1" standoff of the CBSQ meets code requirements for structural posts installed in basements or exposed to weather or water splash
- Included fasteners provide faster installation than bolts
- SDS Heavy-Duty Connector screws that provide a greater wood net section area than bolts
Material
- See table
Finish
- Galvanized; some models available in HDG or stainless steel
Installation
- Use all specified fasteners; see General Notes.
- Install 1/4" x 2" Strong-Drive SDS Heavy-Duty Connector screws, which are provided with the column base. (Lag screws will not achieve the same load.)
- Install CBSQ with bottom of standoff flush to top of concrete
- Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non-top-supported installations (such as fences or unbraced carports).
Ordering Information
- To order with screws, specify CBSQ-SDS2
- To order without screws, specify CBSQ
Related Literature
Load Tables
These products are available with additional corrosion protection.
For stainless-steel fasteners, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
- Loads may not be increased for duration of load.
- For higher downloads, pack grout solid under 1" standoff plate before installation. Base download on column or concrete, according to the code.
- Concrete shall have a minimum compressive strength of f'c = 2,500 psi.
- Multiply seismic and wind ASD uplift and lateral load values by 1.43 or 1.67, respectively, to obtain LRF D capacities.
- For lateral loads for all CBSQ models: F1 allowable = 485 lb., F2 allowable = 1,270 lb. Minimum 3" side cover required.
- In accordance with IBC, Section 1613.1, detached one- and two-family dwellings in Seismic Design Category (SDC) C may use "Wind and SDC A&B" allowable loads.
- Downloads shall be reduced where limited by capacity of the post.
- Designer is responsible for concrete design.
- Structural composite lumber columns have sides that show either the wide face or the edges of the lumber strands/veneers known as the narrow face. Values in the tables reflect installation into the wide face. See technical bulletin T-C-SCLCLM for load reductions resulting from narrow-face installations.
- Fasteners: SD and SDS screws are Simpson Strong-Tie® Strong-Drive® screws. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
Code Reports & Compliance
Drawings
| DWG | DXF | RFA | IFC | SAT | |||
|---|---|---|---|---|---|---|---|
