H2A Hurricane Tie
Roof Truss and Rafter Connectors, Ties, and Straps
This product's information may differ depending on the category of use. You are currently viewing details related to Roof Truss and Rafter Connectors, Ties, and Straps. You can also view product information related to the category: Seismic and Hurricane Ties
Product Details
The H2A single-sided hurricane tie makes a direct connection between the rafter or truss, the top plates and the wall studs. A value-added solution for high-wind applications, it is designed to resist uplift and lateral loads. By capturing all three framing members, the H2A eliminates the need for a separate top-plate-to-stud connection.
Key Features
- Forms part of a continuous load path to resist wind and seismic forces
- Suitable for both wood and cold-formed steel applications
Material
- 18 ga.
Finish
- Galvanized (G90), stainless steel or ZMAX® coating; see Corrosion Information
Installation
- Use all specified fasteners; see General Notes.
- Hurricane ties do not replace solid blocking.
- When installing ties on plated trusses (on the side opposite the truss plate) do not fasten through the truss plate from behind. This can force the truss plate off of the truss and compromise truss performance.
Related Literature
Product Information Table
| Model No. | Ga. | Coating/Material | Packaging Qty. |
|---|---|---|---|
| H2A | 18 | Zinc Galvanized, G90 | 1 |
| H2ASS | 18 | Stainless Steel | 1 |
| H2AZ | 18 | ZMAX® | 1 |
Load Tables
Load Values with Carbon Steel Nails
These products are available with additional corrosion protection.
For stainless-steel fasteners, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
- See Straps and Ties General Notes.
- Allowable loads are for one anchor. A minimum rafter thickness of 2 1/2” must be used when framing anchors are used on each side of the joist and on the same side of the plate (exception: connectors installed such that nails on opposite side don’t interfere).
- Allowable loads in the F1 direction are not intended to replace diaphragm boundary members and do not account for possible cross-grain bending of the truss or rafter members.
- When cross-grain bending or cross-grain tension cannot be avoided in the members, mechanical reinforcement to resist such forces shall be considered by the designer.
- Some load values for the stainless-steel connectors shown here are lower than those for the carbon-steel versions. Ongoing test programs have shown this also to be the case with other stainless-steel connectors in the product line that are installed with nails. Visit General Corrosion Risks for updated information.
- The allowable loads of stainless-steel connectors match carbon-steel connectors when installed with stainless-steel Strong-Drive® SCNR Ring-Shank Connector nails. For more information, refer to engineering letter L-F-SSNAILS.
- Simpson Strong-Tie offers stainless-steel Strong-Drive® SCNR Ring-Shank Connector nails. SCNR nails are available in paper-collated strips and in bulk for hand-drive fastening. See general fastener information.
- Fasteners: Nail dimensions in the table are listed diameter by length. For general fastener information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
- Using Strong-Drive SD Connector (SD9112) for 0.131” x 1 1/2” will get the same load as nails.
Code Reports & Compliance
Drawings
| DWG | DXF | RFA | IFC | SAT | |||
|---|---|---|---|---|---|---|---|
